[. . . ] J Fitted units must be heatĆresistant up to 90 ºC, and neighbouring unit fronts up to 70 ºC. J Cut out the units and the work surface before fitting the appliances. [. . . ] J Cut out the units and the work surface before fitting the appliances. Remove any shavings or the function of the electrical components may be impaired. J The power socket for the appliance must either be located in the hatched area B or else away from the installation space. J A gap of 5 mm is required between the appliance and surrounding unit fronts. There must be a ventilation cutĆout made in the intermediate floor of the surround unit. If a fitted oven is to be built in under a hob, pay attention to the hob installation instructions. If the plug is no longer accessible following installation, an allĆpole isolating switch must be present on the installation side with a contact gap of at least 3 mm. An allĆpole isolating switch with at least a 3 mm contact gap must be available for the installation. Only in Sweden, Finland and Norway The appliance can also be connected using the plug provided which has an earthing contact system. If this is not the case, an allĆpole isolating switch must be used on the installation side with a contact gap of at least 3 mm. 2+4 GB et Australie uniquement Securing the appliance Ć Figure 5 J If necessary, fit the spacer. J The gap between the worktop and the appliance must not be closed using additional battens. [. . . ] If this is not the case, an allĆpole isolating switch must be used on the installation side with a contact gap of at least 3 mm. 2+4 GB et Australie uniquement Securing the appliance Ć Figure 5 J If necessary, fit the spacer. [. . . ]